CryoTune Performance Arvada, Colorado 39.79°N 105.07°W Est. 2008

Cold air. Hard numbers.

Calibration, service and builds for performance cars — dialed in on our in-house AWD dyno, a mile above sea level.

Scroll

00What you're looking at

That surface is a timing map — the table a calibrator shapes cell by cell until an engine pulls clean. Each line across it is a revision: log, adjust, pull again, climb a little higher. Ours happen to look like the Front Range. Since 2008 we've been reading both.

2008Founded
15+Years of pro calibration
2,000HP dyno capacity, AWD
10Revisions per e-tune

01Disciplines

Four ways
we make it
better.

Keep scrolling →

01

E-Tuning

Custom calibrations delivered by email, anywhere on earth. COBB Accessport Stage 1, 2 and 3 for turbo Subarus and the Infiniti VR30.

  • Base map within 72 hours
  • Up to 10 revisions in 30 days
  • Better driveability, refined power
See the stages
02

Dyno Tuning

Calibrated in person on our linked-AWD Mustang dyno. Up to four maps per session — low power, high power, valet, flex fuel.

  • From $750 per calibration
  • Subaru flex fuel — $1,300
  • EcuTek Master Tuner
Meet the dyno
03

Service

Factory schedules to full engine replacements — a safe place for stock and modified cars alike, with straight communication the whole way.

  • 30 / 60 / 90K & timing belt
  • Clutch, brakes, walnut blasting
  • Pre-purchase inspections
Schedule service
04

Performance

Brakes and suspension to full custom builds. Fuel systems, cooling, turbo and supercharger installs matched to your power goal.

  • Garrett · Blouch · Forced Performance
  • Whipple · ProCharger
  • Parts counter for DIY
Plan a build

02The build

Cold is
horsepower.

Dense air makes power; heat takes it away. Every build we plan starts with where the air goes, what it takes to keep it cold, and whether fuel and brakes can keep up.

  1. 01

    Cooling

    Radiators, heat exchangers and air-to-air intercoolers that keep intake temps in check.

  2. 02

    Forced induction

    Turbo and supercharger installs — Garrett, Blouch, Forced Performance, Whipple, ProCharger.

  3. 03

    Fuel systems

    Setups engineered per platform, for when the factory lines run out of headroom.

  4. 04

    Brakes & suspension

    Coilovers, sway bars, bushings, pads, lines and rotors — handling to match the power.

Build planner · 2016 STI example Stock to 400 whp.
Plan it before you buy it.
Open the planner→

03The Dyno

Truth, at all
four wheels.

A Mustang MD-AWD-150-SE: front and rear rollers mechanically linked, so an all-wheel-drive car sees a dry road — not a traction event. No fighting the diff. Just the number.

2000RPM
000WHP
000LB-FT

Illustrative pull — not a customer result

  • 2,000 hpmeasurement capacity, AWD
  • 625 hpeddy-current load, K140 absorber
  • Linkedfront / rear roller sync
  • In-houseArvada, Colorado

—Dyno rates

Prices vary by model and the work performed. Retuning for new parts? Email us — partial retunes are a thing.

04E-Tune

Your driveway.
Our calibration.

For 02–23 WRX, 05–09 Legacy GT & Outback XT, and 04–18 Forester XT on the COBB Accessport. You log, we revise, until it's right.

  1. S1

    Stage 1

    Stock turbo, stock downpipe. Intakes and boost controllers welcome.

    No wideband needed
  2. S2

    Stage 2

    Stock turbo with an aftermarket catted downpipe.

    No wideband needed
  3. S3

    Stage 3 Stock fueling

    Stage 2 hardware plus a swapped turbo — VF52, VF48, VF39, 16G — on factory injectors.

    No wideband needed
  4. S3+

    Stage 3 Aftermarket fueling

    Stage 2 hardware plus aftermarket injectors — COBB, Injector Dynamics, DeatschWerks.

    Wideband O₂ required
T–7 days

Plan

Reach out a week ahead — ideally before the parts go on.

+24 hrs

Instructions

Setup and logging guide lands in your inbox.

+72 hrs

Base map

Your first calibration, Monday through Friday.

30 days

Log & revise

Up to ten revisions while the hardware stays the same.

We do not calibrate vehicles with emissions components removed.

05Platforms

Fluent in
more than boxer.

COBB
Accessport

  • Subaru turbo models
  • Ford EcoBoost
  • BMW E-series N54 / N55
  • VW GTI / Golf R

EcuTek
Master Tuner

  • Infiniti VR30 3.0 twin-turbo
  • BMW F-series N55 · S55 M3/M4 · 340i
  • Toyota Supra 2020–21
  • BRZ / FR-S / 86

APR &
Integrated Eng.

  • Authorized vendor
  • Audi / Volkswagen
  • Euro hardware & software

HP
Tuners

  • Select models
  • Flex fuel & dual-map
  • Call or email to check yours

Service & repairSubaru · Lexus · Toyota · Acura · Honda · Chevrolet · Ford · Hyundai · Kia · Infiniti

Customers and their cars gathered outside the CryoTune Performance shop in Arvada
5270 Marshall St — Unit A Car people,
fixing cars
for car people.

06The calibrator

Dave
Bigley

Dave Bigley, lead calibration specialist, in the CryoTune shop
Lead calibration specialist

Dave cut his teeth on Subaru, Mitsubishi, Ford, Chevy, Audi and Volkswagen, then fell hard for direct injection. He's been calibrating professionally for over fifteen years — and still goes looking for the next thing to learn.

  • 01EFI UniversityCertified Tuner
  • 02COBB TuningCertified Protuner
  • 03AEM InfinityFactory trained
  • 04EcuTekMaster Tuner

07From the driver's seat

I made the drive from Colorado Springs to check this place out, and I'm so happy I did. I got my first pro tune on my 2019 Subaru WRX STI, and couldn't be more happy with the results. Jackson and Dave walked me through the whole process. They are most definitely worth the drive.

Brittany Allwein2019 WRX STI · via Facebook

08Book a session

Bring it in.

(720) 372-2907
Emailsales@cryotuneperformance.com
Shop5270 Marshall Street, Unit A
Arvada, CO 80002
After hours

Night drop-off and pick-up — just ask and we'll coordinate.

Parts counter

OEM and aftermarket over the counter. Direct distributor for most performance lines.